Loading... Please wait...
Check out E Airtool 1 on Yelp

Pneumatic Double Diaphragm Sump Pump 2" Wilden M8 / T8

Hover over image to zoom

  • Image 1
  • Image 2
Wilden
$249.99
SKU:
M8
Availability:
In Stock
Shipping:
Calculated at checkout
Current Stock:
1

 Product Description

Pneumatic Double Diaphragm Pump by Wilden

Model: M8 (now called the Turbo Flo series T8 by Wilden)

Height...............................668 mm (26.3")<>

Width................................404 mm (15.9")

Depth................................343 mm (13.5")

Air Inlet ...................................19 mm (3/4")

Inlet .........................................51 mm (2")

Outlet.......................................51 mm (2")

Suction Lift .......................6.4 m Dry (21')

9.5 m Wet (31')

Displacement per

Stroke ..................... 2.69 L (0.71 gal.)1

Max. Flow Rate...........617 lpm (163 gpm)

Max. Size Solids.....................6.4 mm (1/4")

OPERATION: The M8/T8 is not pre-lubricated, and may require in-line lubrication and an air inlet regulator. Pump discharge rate can be controlled by limiting the volume and/or pressure of the air supply to the pump (preferred method). An air regulator is used to regulate air pressure. A needle valve is used to regulate volume.

Pump discharge rate can also be controlled by throttling the pump discharge by partially closing a valve in the discharge line of the pump. This action increases friction loss which reduces flow rate. This is useful when the need exists to control the pump from a remote location.

When the pump discharge pressure equals or exceeds the air supply pressure, the pump will stop; no bypass or pressure relief valve is needed, and pump damage will not occur. The pump has reached a “deadhead” situation and can be restarted by reducing the fluid discharge pressure or increasing the air inlet pressure. This Wilden T8 pump runs solely on compressed air and does not generate heat, therefore your process fluid temperature will not be affected.

 

This pump has been tested and is working great! It has a rubber or Buna wettable diagram in it so it is good for pumping water. If you need to pump methanol, alcohol, fuel or any other substance you will need to purchase a wettable kit for this pump from your local Wilden distributor. Diaphragms are made of different materials depending on what you are pumping. This pump is currently designed for water. Kits are easy to change out and you will receive instructions with the unit.

An important note: You may need to back your air pressure down a bit when using a compressor such as an IR-185 or Sullair 125 Pull Behind Air Compressor. These pumps do not run correctly or may not run at all if too much air pressure is applied!! Start slow and apply more air pressure as needed. The amount of air pressure you need will depend on the height of the pump above the material, length of intake hose, type of material you are pumping ect...

 

This pump comes with manual and parts print.

 

Manual: http://www.e-airtool.com/EBAY/Pumps/A8T8M-ORG-MTL-EOM.pdf

 


PLEASE CALL OR EMAIL FOR YOUR FREIGHT QUOTE BEFORE CHECKING OUT