Pneumatic 1/4" Female Hex Pulse Wrench Uryu Aimco by URYU
Capacity Nominal Bolt Size: 5mm (No. 10)
Torque Range: 6-11 Nm (4.4-8.1 ft. lbs)
Free Speed Output .5MPa 5200 .6MPa 5500
Overall Length: 246 mm (9 11/16")
Weight less socket: .93 Kg (2 lbs)
Center to Side: 22.5 mm (57/64")
Square Drive: 6.35 mm (1/4" )
Average Air Consumption: .25 m3/min (8.8 Ft3/min)
Noise dB(A): 75
Vibration Level m/sec2: 1.5
Torque reaction is virtually eliminated to reduce wrist injury to operator and create ergonomic working environment.
Optimum torque accuracy and repeatability.
Uniform fastening torque with narrow mean-shift torque for hard and soft joints thanks to a unique torque control shut-off device (no timer).
External one-touch adjustment for automatic shut-off.
Uryu quality and design.
SETTING OF TIGHTENING TORQUE
LINE SIZE: 3/8 to 1/2 drive should use 3/8 ID line and 3/4 to 1 drive should use 1/2 ID line.
AIR PRESSURE: Use air pressure 5.0 - 6.0 Kgf / cm2 (70-85 PSI) for optimum performance. Caution: Never use higher air pressure to increase the
output of the tool. Overloading will drastically shorten the life of all internal parts.
DRY AND CLEAN AIR: Drain daily, and install filter at or near the take-off point to prevent trouble from foreign matter.
AIR HOSE AND JOINTS: Use air hose (the shorter, the better), joints, and other fittings of good condition and of proper size to avoid pressure drop.
REGULAR OVERHAUL: It is recommended that after every 150,000 pulsing seconds or 180 days the fluid in the tools pulse unit be changed. It
is also recommended at such time to grease the bearings in the air motor. If the presence of water is noted, it is recommended that a small amount of
oil be run through the air motor to wash out any rust residue in the air motor. It is recommended that after every 300,000 pulsing seconds or 365 days
that a pulse unit repair kit be installed in the pulse unit. This also allows the inspection of hard parts in the pulse unit.
All tools (NEW and REBUILT) have a 30 day warranty through us from the day you receive your tool so please use your tool at least once within 30 days of receiving it. The only tools that do not come with a 30 day warranty are tools that are stated as (USED). Used tools are only guaranteed to be in working condition when you receive them! In the event your tool has a warranty issue your tool will be repaired free of charge. If your tool cannot be repaired your tool will be replaced with one of the same make and model or you will be refunded completely. There is a 20% restocking fee on tools that are decided not correct for the job unless a larger or more expensive tool is purchased so please contact us if you are unsure what you need and we can help you determine what you need for the job.
ALL INTERNATIONAL CREDIT CARDS WILL BE CHARGED AN ADDITIONAL 10.00
IF YOU PURCHASE MORE THAN 1 ITEM YOUR CARD WILL ONLY BE CHARGED ONCE.
All customers located in the state of Michigan will be charged 6% Sales Tax
This product hasn't received any reviews yet. Be the first to review this product!
All prices are in USD.